Home >X ev3downloads

EV3 Blocks

LEGO MINDSTORMS® Users Can Use TETRIX!

Hardware Required

Software Downloads/Instructions

(Note: Some antivirus programs may interfere with download)

  • Get Started with TETRIX and EV3 (.ev3 file, 3MB)
  • EV3 TETRIX Blocks (.zip file, 4MB)
  • Block Import Instructions (.pdf file, 168KB)
  • Products

    The HiTechnic DC Motor Controller for TETRIX® connects to an EV3 Intelligent Brick sensor port and enables you to control powerful DC motors for use with TETRIX robots. The controller has two H-bridge outputs to control the speed and direction of two DC motors and is designed to connect to the TETRIX hole pattern.

    $89.95 $75.00

    The HiTechnic Servo Motor Controller for TETRIX® connects to an EV3 Intelligent Brick sensor port and enables you to control up to six R/C-type servo motors for use with TETRIX robots, enabling you to add proportional positioning to your robotic creations.

    $79.95 $65.00

    Want to connect a TETRIX® MAX robot to LEGO® elements? It’s not a problem with this TETRIX Hard Point Connector that was designed to enable LEGO Technic elements to be connected to the TETRIX MAX building system.

    $3.95

    Use this 10-cell, 12-volt rechargeable pack to bring long-lasting power to TETRIX® motors and electronics. This 3,000 mAh NiMH pack features a built-in, 20-amp replaceable fuse for safety.

    $49.95

    Use to recharge the TETRIX® 12-Volt Rechargeable Battery Pack (39057) and the 12-Volt Battery Pack (41135). This NiMH charger auto detects battery pack voltage, sets up proper charging voltage, and cuts off power automatically by negative delta V IC when the battery pack is fully charged – protecting the battery from overcurrent, short circuit, and reverse polarity.

    $34.95 $24.95